How To Start A Manual Regeneration

Normally, when it’s time for a regeneration of your water softener, the system performs it automatically and the process is completed with no work on your end. However, on occasion, there could be the need to flush the system multiple times, which requires a manual regeneration. 

 

To do this, you’ll press the Regen button on your system display screen once, and be sure that you see the “Regen Today” message pop up on the screen. When you’ve seen the flashing message, press and hold the Regen button again for 5 seconds to jumpstart the regeneration process. As the system begins regenerating, it is also queued to begin another regeneration at its normal, preset time. 

 

If you’re experiencing difficulty with your water treatment systems, or have more questions about manual regeneration, reach out today!

Top
website powered by
Service Area
Contact